[et_pb_section fb_built=”1″ admin_label=”section” _builder_version=”4.16″ global_colors_info=”{}”][et_pb_row admin_label=”row” _builder_version=”4.16″ background_size=”initial” background_position=”top_left” background_repeat=”repeat” global_colors_info=”{}”][et_pb_column type=”4_4″ _builder_version=”4.16″ custom_padding=”|||” global_colors_info=”{}” custom_padding__hover=”|||”][et_pb_text admin_label=”Text” _builder_version=”4.16″ background_size=”initial” background_position=”top_left” background_repeat=”repeat” global_colors_info=”{}”]

The chart below is only a guide. In order to assure correct sensor selection for your application, we recommend contacting us directly.

Select the Proper Sensor from the Table

  1. Locate the pin size that will be used and match it to the location on the part (Near the End of Fill or Near the Gate).
  2. The intersection of the row and column is the sensor to use (Lynx Strain Gage or Piezo based on the mold application).

Key

Normal Pressure, (e.g. Typical Molds, End of Cavity)

5000 PSI / 350 Bar / 35 MPa

High Pressure (e.g. Thin Wall, Post Gate)

10,000 PSI / 700 Bar / 70 MPa

[/et_pb_text][/et_pb_column][/et_pb_row][/et_pb_section]